Make sure you have the latest firmware for your controller. The examples below are assuming you have just a keyboard and bluetooth dongle plugged into your Pi. The following guide is geared to using a controller from 8bitdo but should work with a range of bluetooth devices.

Manual Bluetooth Configuration !!Please note this is for pre v4.0 RetroPie - New 8bitdo details here!! Add dtoverlay=pi3-disable-bt in /boot/config.txt to disable internal BT module (ultima ratio, speeds up communication, extents range and speed depending on your BT adapter model) Buy a new BT adapter and put it to your Raspberry.Smaller values of 115200 have been known to alleviate input lag / ghost input on a Pi 3B. Try forcing a lower baud rate in /usr/bin/btuart, on line 22: $HCIATTACH /dev/serial1 bcm43xx xxxxxx noflow - $BDADDR.Try to disable internal WiFi - this helps to extent signal strength, you can use this script to disable/enable Wifi on the fly (several users report PS3 controller connections problems are vanished since).Try reducing distance from your controller to Raspberry (helps sometimes).Display Registered & Connected Bluetooth Devices: This will display the current bluetooth devices connected.Ĭonnection issues (input lag & ghost inputs) (especially if you connect more than one BT controller) Disconnect Bluetooth Devices: You can disconnect your bluetooth device from this menuģ. If it was not successful make sure that you chose the correct mac address, if it still doesn't work you may have to configure it manually (see below).Ģ. You will get a window popping up telling you if the connection was successful or not. Register and Connect Bluetooth Devices: You can select your bluetooth device's mac address from here It can also be accessed from RetroPie-Setup Script > Setup > Configure Bluetooth Devicesġ. You can access the bluetooth configuration menu from the RetroPie Menu of EmulationStation. There are also manual methods that may vary depending on what Bluetooth controller you are using, some of which are described further below on this page. The simplest way of setting up a Bluetooth controller is through the Bluetooth Configuration menu of the RetroPie Setup script. Adding a Bluetooth controller to RetroPie

If you want to use a bluetooth dongle with the pi3, you should first disable the onboard BT controller by adding dtoverlay=pi3-disable-bt to /boot/config.txt, then rebooting and plugging your dongle, which should now work. If it asks you anything about the /etc/udev/rules.d/les configuration file, type Y to overwrite.

Universal Controller Calibration & Mapping Using xboxdrvĬonvert RetroPie SD Card Image to NOOBS Image Pi 3 Bluetooth Freeze Fix (for RetroPie 3.7 or below) Validating, Rebuilding, and Filtering Arcade ROMs

Ps3 mac address range